.. :orphan: Main Menu ========= .. image:: images/devo10/ch_mainmenu/main_menu.png :align: center The main menu selections of the Deviation firmware are accessed by momentarily pressing the ENT button on the bottom right of the transmitter. The main menu consists of the following four options: Model menu, Transmitter menu, USB and About Deviation. All settings which pertain to the usage of your Devention transmitter are accessed from the main menu. They include model options, language selection, display options, buzzer, vibration, stick mode, calibration, USB connectivity as well as version information. Model menu ---------- The model menu is the area within Deviation that you can configure the type of aircraft you are flying. All model data is managed and saved within this menu selection. Details of the menu are located in section :ref:`model-menu`. Transmitter menu ---------------- The transmitter menu allows you to select transmitter-specific options as well as monitor channel output & stick input, and monitor telemetry (if available). Details of the menu are located in section :ref:`transmitter-menu`. USB --- .. image:: images/devo10/ch_mainmenu/usb.png :align: center The USB page can be accessed by selecting ‘USB’ from the main menu. USB mode can then be toggled on/off to enable access to the transmitter’s file-system from a USB equipped computer. In this mode the file system of Deviation is accessible as a mass storage device. This will allow you to move files back and forth between the Deviation file-system and a PC. All configuration files are accessible in this mode. .. cssclass:: bold-italic NOTE: Entering USB mode should never be done while the model is bound, USB usage will disrupt signal transmission! About Deviation --------------- .. image:: images/devo10/ch_mainmenu/about.png :align: center The Deviation release version can be accessed by selecting ‘About Deviation’ from the main menu.