===== Blade 180 QX HD =====

This model was made by kreidler. http://deviationtx.com/forum/model-configs/2561-blade-180-qx#18088

I added DR/EXPO functions and added my custom GUI which also includes

Battery and TxPower to the b/w screens.

Model 37 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S.

* This model will not work for deviation firmware v2.1 or v3.

The Devo 7e only has two flight modes FMOD0 and FMOD1 and this model is made for three flight modes: FMOD0 - FMOD1 - FMOD2

The flight mode switches between Stability mode with low flight angles, Stability mode with high flight angles, and Agility mode.

kreidler has a model for the Devo 7e with a 3 switch mod.

http://deviationtx.com/forum/model-configs/2561-blade-180-qx#18088
  * Throttle hold on the RUDD D/R switch.  * TX Power=100mW  * Channels=6  * Protocol=DSMX  * No Fixed ID  * Model Type=Plane  * Stick Mode 2
If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings.

The Blade 180 QX HD owners manual has these settings below for High Rate/Low Rate listed for all these transmitters: DX6i, DX7/7SE, DX7S, DX8, DX9/DX18

They do not list any Expo settings.

You can add EXPO if you want. I suggest +30% as a starting point and adjust it up or down from there.

DR/EXPO

Switch Position

0- ELEV D/R = 70% EXP LIN

0- AILE D/R = 70% EXP LIN

RUDD D/R = 100% EXP LIN

Switch Position

1- ELEV D/R = 100% EXP LIN

1- AILE D/R = 100% EXP LIN

RUDD D/R = 100% EXP LIN

Turn up RUD Scale -/+ to 150 if you want faster piros.

{{ .:blade_180_qx_hd:deviation4-rud.jpg }} 

Download the Configuration Settings File.

Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox.

Install the configuration settings file into your models folder (See my How to video below).

This will over-right the current file so make sure that model slot doesn’t

have a model being used in it. If it does rename the configuration settings file

to another number that you have free.

Example: The file you downloaded is named model5 so change the “5" to another slot

number that you don’t have a model setup for. If you have model slot 6 open rename the file to model6

How to Import/Export Deviation Firmware Models

http://youtu.be/aXkvtbCXzsk

-

[[ .:blade_180_qx_hd:model37_2014-01-27 ]]