===== Nine Eagles Solo Pro 125 - Standard Settings ===== Nine Eagles Solo Pro 125 (125A) * Low dual rates and positive expo to tame the heli down * Throttle hold on the RUDD D/R switch * 7 Point Throttle and Pitch Curves * TX Power=100mW * Channels=6 * Protocol=J6Pro * No Fixed ID * Stick Mode 2 If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings. Model 46 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S. * This model will not work for deviation firmware v2.1 or v3. __Gyro Gain__ - These are the values I used then converted them to the deviation values. Gear Switch Pos 0: 38% Pos 1: 75% __Throttle Curve__ Normal: Custom Curve ST-1: 100% Flat Across ST-2: 100% Flat Across Throttle Hold is active on RUDD D/R switch __Pitch Curve__ Normal: -3* negative pitch. Hover at about half throttle. ST-1: Full +/- 3D pitch curve. Zero degrees pitch at mid stick. ST-2: Full +/- 3D pitch curve. Zero degrees pitch at mid stick. __DR/EXPO__ Adjust D/R and EXPO to your personal preference. Switch Position 0- ELEV D/R = 70% EXP +30% 0- AILE D/R = 70% EXP +30% RUDD D/R = 100% EXP LIN Switch Position 1- ELEV D/R = 100% EXP LIN 1- AILE D/R = 100% EXP LIN RUDD D/R = 100% EXP LIN Download the Configuration Settings File. Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox. Install the configuration settings file into your models folder (See my How to video below). This will over-right the current file so make sure that model slot doesn’t have a model being used in it. If it does rename the configuration settings file to another number that you have free. Example: The file you downloaded is named model5 so change the “5" to another slot number that you don’t have a model setup for. If you have model slot 6 open rename the file to model6 How to Import/Export Deviation Firmware Models http://youtu.be/aXkvtbCXzsk - [[ .:nine_eagles_solo_pro_125_-_standard_settings:model46 ]]