https://www.deviationtx.com/wiki/ 2026-04-09T00:48:37-0700 https://www.deviationtx.com/wiki/ https://www.deviationtx.com/wiki/lib/tpl/devowiki/images/favicon.ico text/html 2016-04-15T12:01:32-0700 Anonymous (anonymous@undisclosed.example.com) https://www.deviationtx.com/wiki/rf_module_installation/devo7e?rev=1460746892&do=diff Installing a module into a Devo7e Transmitter Prepare Devo Transmitter First Remove the screws from the back of the Devo7e Transmitter Devo7e: There are 5 screws on the back of the Devo7e. You must rmeove the inlaid grips on the back to expose two of them. You will also need to remove the rubber grips on the sides to separate the two halves. It may be necessary to use a knife to cut through tamper-sticker on the bottom. text/html 2016-04-15T12:01:49-0700 Anonymous (anonymous@undisclosed.example.com) https://www.deviationtx.com/wiki/rf_module_installation/devo8?rev=1460746909&do=diff Installing a module into a Devo8 Transmitter Prepare Devo Transmitter First Remove the screws from the back of the Devo8 Transmitter Devo8: There are 5 screws on the back of the Devo8. It may be necessary to use a knife to cut through tamper-sticker on the bottom. text/html 2016-04-15T12:02:06-0700 Anonymous (anonymous@undisclosed.example.com) https://www.deviationtx.com/wiki/rf_module_installation/enabling_modules?rev=1460746926&do=diff Enabling External Modules to Your Deviation Transmitter Introduction The Deviation firmware implements several protocols that the Devo series radios do not have the necessary hardware to support. To use these protocols, it is necessary to install additional 2.4GHz transceiver modules. Please see text/html 2016-04-15T12:02:22-0700 Anonymous (anonymous@undisclosed.example.com) https://www.deviationtx.com/wiki/rf_module_installation/remove_skyartec?rev=1460746942&do=diff Removing an CC2500 module from a Skyartec 701 Step 1: Disassemble the NASA701 transmitter The 1st step is to remove the back cover from the Skyartec transmitter. Remove the 9 screws from the back of the transmitter as well as the rubber sides. text/html 2016-04-14T20:02:49-0700 Anonymous (anonymous@undisclosed.example.com) https://www.deviationtx.com/wiki/rf_module_installation/remove_v911?rev=1460689369&do=diff V911 Module Removal Note: There are a few WLToys transmitters that do not contain an A7105 module and cannot be used for these procedure. An example is the V202 transmitter. Note that these transmitters may be labeled as V929/V939 even though they are not actually compatible with those models.