Joomla says you aren't logged in
release_notes:5.0.0
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
release_notes:5.0.0 [2016/05/01 01:18] FDR [Version 5.0.0] |
release_notes:5.0.0 [2016/05/25 09:56] Arnold [Minor Features / Bug Fixes] |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| **IMPORTANT:**\\ | **IMPORTANT:**\\ | ||
| **You must install the filesystem along with the new firmware. Make sure to save your models first!**\\ | **You must install the filesystem along with the new firmware. Make sure to save your models first!**\\ | ||
| - | **The configuration of hardware mods has changed since the previous 4.0.1 version. Instead of the tx.ini, they are in a new hardware.ini file, just like it was in the last nightly builds.** | + | **The configuration of hardware mods has changed since the previous 4.0.1 version. Instead of the tx.ini, they are in a new hardware.ini file, just like they were in the last nightly builds.** |
| ==== Installation ==== | ==== Installation ==== | ||
| Line 40: | Line 40: | ||
| * YD717 - Enable high-rate mode | * YD717 - Enable high-rate mode | ||
| * YD717 - Support receiver throttle saftey | * YD717 - Support receiver throttle saftey | ||
| - | * YD717 - Don't hange the transmitter waiting fro a response from the model | + | * YD717 - Don't hang the transmitter waiting for a response from the model |
| * Properly handle Tx mode in Hubsan protocol | * Properly handle Tx mode in Hubsan protocol | ||
| * DSM2/X - telemetry display fixes. Support temperature display | * DSM2/X - telemetry display fixes. Support temperature display | ||
release_notes/5.0.0.txt (23332 views) ยท Last modified: 2017/05/17 08:03 by Texacate
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
