HiSky HCP100S with nRF soldered

More
21 Dec 2014 15:25 - 02 Feb 2015 09:08 #27120 by matrixFLYER
HiSky HCP100S with nRF soldered was created by matrixFLYER
FMODE 0/1/2 = Throttle LOW/MEDIUM/HIGH (always the same pitch curve, no normal mode)

RUDD DR0 Throttle HOLD

AILE DR1 reset timer



For Devo10

File Attachment:

File Name: model16_20...2-22.ini
File Size:4 KB
Attachments:
Last edit: 02 Feb 2015 09:08 by matrixFLYER.

Please Log in or Create an account to join the conversation.

More
22 Dec 2014 07:49 #27140 by MarkusR
Replied by MarkusR on topic HiSky HCP100S
No time for a full test, but my bird binds and hovering perfect. Thanks a lot.

Please Log in or Create an account to join the conversation.

More
22 Dec 2014 22:37 - 22 Dec 2014 22:39 #27153 by matrixFLYER
Replied by matrixFLYER on topic HiSky HCP100S
I just deleted the previous setting and put a new file. The olny difference is a better pitch limit. There was too much pitch. The timer is now set at 5 minutes but it can hold even more time on the original lipo.
Last edit: 22 Dec 2014 22:39 by matrixFLYER.

Please Log in or Create an account to join the conversation.

More
02 Feb 2015 06:46 #28340 by joeclone
Replied by joeclone on topic HiSky HCP100S
Has there been any new development for the Hisky protocol to support the HCP100S? Is the HCP100s supported for 7 channels or 6 channels?

Please Log in or Create an account to join the conversation.

More
02 Feb 2015 09:08 #28343 by matrixFLYER
Replied by matrixFLYER on topic HiSky HCP100S

joeclone wrote: Has there been any new development for the Hisky protocol to support the HCP100S? Is the HCP100s supported for 7 channels or 6 channels?

This is for nRf soldered

Please Log in or Create an account to join the conversation.

Time to create page: 0.031 seconds
Powered by Kunena Forum