Some questions about DR switches and mixers

Start
Prev
1
Next
End

sbstnp
Topic Author
Offline

05 Nov 2012 17:33 - 05 Nov 2012 17:34 #2701 by sbstnp

Some questions about DR switches and mixers was created by sbstnp

This is just a cosmetic matter.

Current implementation for Devo 10 is treating position zero for DR switches as High Rates.

Is there a reasoning behind it? Suvsuv?

Or can we treat them equally and just differentiate like in the official firmware as Pos0, Pos1, Pos2?

I'm asking this because I treat them exactly the opposite way, with position zero being the lowest rates then progressively upping the values.

Devo 10 + 4in1
~~Spektrum Dx9~~
FrSky Taranis + TBS Crossfire

Last edit: 05 Nov 2012 17:34 by sbstnp.

Please Log in or Create an account to join the conversation.

PhracturedBlue
Offline

05 Nov 2012 17:59 #2703 by PhracturedBlue

Replied by PhracturedBlue on topic Some questions about DR switches and mixers

It needs to match how the Devo8 is done so that models can be shared between the firmwares. I don't have a Tx in front of me, but in the end, this will be the deciding factor.

Please Log in or Create an account to join the conversation.

suvsuv
Offline

05 Nov 2012 18:27 #2704 by suvsuv

Replied by suvsuv on topic Some questions about DR switches and mixers

sbstnp wrote: This is just a cosmetic matter.

Current implementation for Devo 10 is treating position zero for DR switches as High Rates.

Is there a reasoning behind it? Suvsuv?

Or can we treat them equally and just differentiate like in the official firmware as Pos0, Pos1, Pos2?

I'm asking this because I treat them exactly the opposite way, with position zero being the lowest rates then progressively upping the values.

I agree with you.
PB, please give me a go or no-go signal once you check out your real devo10

Please Log in or Create an account to join the conversation.