AUX5 does not calibrate with T8SG V2 Plus and V3

AUX 5 does not store calibration values when performing analog calibration with T8SG V2 Plus. There is no problem with older firmware.
With the new T8SG V2 Plus (V3) carbon color, the 'saving' voice talks twice and says the 'welcome deviation' when the power is turned on.

It was the same with two T8SG V2 Plus carbon patterns.
At power on, we talk that the audio is not relevant twice. The internal PCB has a new audio playback circuit.
Maybe you need some initialization? . Do you need hardware processing? .

AUX5 of my T8SG V2+(carbon) does not work either.

Calibration rewrites < tx.ini > file as below.

---

[calibrate5]
max=4095
min=0
zero=2047
[calibrate6]
max=0
min=0
zero=0

---

It is a bug of the Deviation.
Hardware is good.
Connect the USB and rewrite < tx.ini > file as below.

---

[calibrate6]
max=4095
min=0
zero=2047

---

Now AUX5 works.

Pao wrote: AUX5 of my T8SG V2+(carbon) does not work either.

Calibration rewrites < tx.ini > file as below.

---

[calibrate5]
max=4095
min=0
zero=2047
[calibrate6]
max=0
min=0
zero=0

---

The calibration problem is working in the same way.
Are the audio problems the same? .
When I go into USB mode or DFU mode, I'm nervous.
It becomes a noisy transmitter.

My T8SG V2+ also say "Saving Saving" when turn on it.
and when USB mode or DFU mode keep saying "Saving Saving Saving ..............".
I want it to be quiet quickly.

Both bugs will be looked into, thanks for reporting.

Proposed fix for calibration issue:
github.com/DeviationTX/deviation/pull/862
Has to be tested yet, if you know how to compile deviation yourself please try it out and report back. Otherwise please have a little patience.

I confirmed that it works properly.
Thank you.

Postscript
The calibration of AUX5 was saved correctly.
The audio problem does not seem to be improved. I do not seem to turn on and make two random utterances.

The F12E and AUX7 built every night also have this problem. Manually modify the tx.ini file to work properly.

Should be resolved in nightlies (the calibration issue, not the voice one).

As I have no V3 (carbon), I can't look deeply into the voice issue. You could try the attached build (based on current nightly) and see if the issue is fixed. Otherwise I'd suggest removing the mp3 for saving, as there is only really two situations where it should be called in mixer setup.

Since the correction version of the calibration problem of AUX5, the two random utterances at power on have disappeared.
However, the power on "wellcome deviation" may not come true.
Your 6dfc826 version was the same.
Thank you for your response.

Missing welcome message is a known issue. Haven't found a good solution yet. Please try out the build 6dfc826 a little bit, it has reworked voice code. It works fine for me, but another tester would be good to have before pulling in the changes.

For the initial audio repeated I suggest ot refer to this topic: https://www.deviationtx.com/forum/6-general-discussions/8425-the-voice-on-the-jumper-t8sg-plus-carbon