New Devo 10?

Hello,

short question.

Does the Deviation software working with the new Devo 10? I mean the white one?
Is it possible to solder the modules into the new Devo 10?

Thanks in advance!

Best regards
Uwe

Thanks!

The only difference, other than being an ugly white w/ orange trim switches, is that the white one has a higher gain antenna on it. I believe a 5dB instead of a 3dB.

If you are more inclined to get a gun metal black one, Walkera Helicopter Supply on San Juan Island, WA., and banggood.com (for a better price if you can stand the wait) in China still have them available.

RedSleds wrote: The only difference, other than being an ugly white w/ orange trim switches, is that the white one has a higher gain antenna on it. I believe a 5dB instead of a 3dB.

If you are more inclined to get a gun metal black one, Walkera Helicopter Supply on San Juan Island, WA., and banggood.com (for a better price if you can stand the wait) in China still have them available.

I like my ugly white one it matches my non tan and a couple of hellis I've got and works great with mods lol

I like the white one very much!
I found this Module with plugged on antenna at BG.
www.banggood.com/DEVO-Transmitter-Tuner-...ys-V922-p-89812.html
At the white Devo 10 the antenna is screwed on the transmitter case. So no possibility to slide the nrf antenna into the stock antenna tube.
Where should i place the nrf antenna? Are there any descriptions for soldering the Modules into the white devo 10?
I will try to avoid a second antenna tube at the transmitter case.

Just put the antenna sideways under the top of the case. Every RF module needs it's own antenna.
Most users are going this way. This is the best angle for RF emission.
Secure the U.FL plug at the module..!

Thanks!

aMax wrote: ........Secure the U.FL plug at the module..!

What are some ways to do this? ....and still be able to un-hook it when needed?

RedSleds wrote:

aMax wrote: ........Secure the U.FL plug at the module..!

What are some ways to do this? ....and still be able to un-hook it when needed?

If not covered with a shrink tubing, a small amount of hot glue will work.
This is my advice in the case the module is not fixed inside the tx.
...just my 2C