- Posts: 3
Devo8S tx_power when using PPM protocol
05 Nov 2015 19:08 #39622
by christian_cph
Devo8S tx_power when using PPM protocol was created by christian_cph
Hi,
I have set up a model for use with my PC and RealFlight. In the Model Setup i have set Protocol to PPM. Everything is working perfect, but when i set the Protocol to PPM, the Tx Power is fixed at Default. It looks like my Devo8S is transmitting at Full Power. In the model.ini i have tried to set tx_power to 100uW, but it is still transmitting at Full Power. It would be nice if I was able to set Tx Power to 0 or at least 100uW, saving the batteries. Is there a way to fix this ? Or maybe this is a suggestion for a future release of Deviation
I have set up a model for use with my PC and RealFlight. In the Model Setup i have set Protocol to PPM. Everything is working perfect, but when i set the Protocol to PPM, the Tx Power is fixed at Default. It looks like my Devo8S is transmitting at Full Power. In the model.ini i have tried to set tx_power to 100uW, but it is still transmitting at Full Power. It would be nice if I was able to set Tx Power to 0 or at least 100uW, saving the batteries. Is there a way to fix this ? Or maybe this is a suggestion for a future release of Deviation
Please Log in or Create an account to join the conversation.
05 Nov 2015 23:44 #39630
by christian_cph
Replied by christian_cph on topic Devo8S tx_power when using PPM protocol
@FDR Sounds good. Thanks for quick response 
Please Log in or Create an account to join the conversation.
Time to create page: 0.311 seconds
-
Home
-
Forum
-
General
-
General Discussions
- Devo8S tx_power when using PPM protocol