Devo f 12e

I have a Devo f 12e I have updated the firmware but I can not upload the model data for the walkera x350 pro, the error I'm getting is "unable to find date for the device/target"
I've checked the drivers in device manager but still I am stuck.
Please help!

I'm new to this but I can tell you I downloaded it from UCDRONE.
does that help?

Yes, I select the file in the config tab and it states the file is successfully loaded. I then click upgrade to upgrade the model data to the transmitter and it says "unable to find data for that device/target in file" and does no upgrade.

I have a F12E to in worst case i try to help you.
Try to use the Version 1.5 (A or B - depends on your F12E) from walkera-fun page
I have read that the 1.6 is reduced to RTF for special models

In this zip file is also the bin file for the x350Pro

Thank you I really appreciate some help with this issue.

I started by using the 1.6 and after some research I tried 1.5A and 1.5B. Each version I try I then go to config tab and input the bin file for the x350 pro, it says file loaded successfully but when I click upgrade it states "unable to find data for that device/target in file"

I'm really stuck

ok - so i will do the same - but version 1.6 is restricted.

I will try this form walkera.fun page downloaded version of 1.5 B - cause i have the 10mW version in test for Deviation software.

I need some time to change back to Walkera firmware. I will tell you my results

Now - i am back

I used all files from walker-fun page - there is a section "download - Transmitter - F12E - and a zip file for version 1.5 this zipfile contains a X350Pro bin

I changed form deviation to walkera firme using devodfuse (also available at this page)

I first install - the firmware with "power on" and "ext" button. After installing the firmware i startet the TX - (throttle warning - cause i am using Mode 2) pull down this stick helps quick.

Then going back in dfu mode (power on and ext) - using in devodfu "config" tab - section of "Upgrade and verify) "...." loading the X350pro file with "open" and starting the Upgrade

After starting the TX - the is the X350Pro (but i see there are a lot of restrictions)


This is what i am doing.

Are you able to download - this files - from walkera-fun ?

If not i try to send you here as attachment

Thank you very much for your time with this issue. Would you mind leaving a link to the walkera-fun page as I'm not 100% sure I'm on the correct page.

Thanks again

You can start with walkera-fans.de and transmit the page to english

Here is the link with the all file for the F12E - and i use the V1.5 which contains firmware and bin for the x350pro

walkera-fans.de/category/sender-modelleinstellungen/devo-f12e/

If you have further problems - send a screenshot of dfuse where i can see if your transmitter is correctly recognized.

No luck. I've tried upgrading the model data in both 1.5A and 1.5B but I'm still getting the same error message

Can you send me a screenshot of your dfuse please ?