I have resolved my problem and am posting the resolution so that it may help others who have searched for an answer
When ordering the Mirage E500, I definitely ordered the Frsky RX. And have screen shots of the purchase to make sure that is what I did.
I set up the Jumper TX and tried many times to bind using Frsky.
Tried changing coarseness in increments of +10 and -10 until it was supposed to bind to no avail.
Using a brand new Jumper TX and never using open source or Devo before I thought it had to be me making a simple error in the binding method.
Tried binding a mates DSMx Rx which worked a treat, so it looked like the TX had no faults.
I looked at the RX under a magnifying glass and the only markings were 8A Ver 2.0
I searched for this RX to no avail there was just no mention of this anywhere.
I happened to look at the Mirage Box and it noticed a label on it “ FLYsky reception”
So the binding started again using Flysky in the Jumper TX . Again to no avail.
I did many searches looking to find mini Flysky RX’s and finally ended up looking in Banggod at a “8/18Ch Mini RX with PPM,Ibus, Sbus output for Flysky it looked very similar to mine.
I started reading the Banggod reviews and found this RX was similar to an FS-ASS. Reading further there was a post stating ”This bound in AFHDS-2A in his Devo 10”
I tried this, and immediately had a bind.
Lack of information in the manual or website caused me many hours of frustration and waste of unfruitful time.
Hope this helps someone
