arduino with protocol Devo

i have a Turnigy 9x , and i want to use control master cp .

i had search internet, but i can not find topic for this project

as i as know, devo use modul CC2500 , and i need protocol arduino + CC2500 to use outPUT PPM from turnigy 9x

anyone can show me Link to this do ?

thanks

The Transmitter built into Devo Radios is NOT the CC2500 but the CYRF6936.

You can add the CC2500 module inside the Tx by 'hacking' it.

sorry, maybe i do not know, okey modul CYRF6936

i only transmitter Turnigy 9x . have not Devo, i can not hacking

maybe i will buy Devo this do .

i can add all nrf24l01,cc2500,a7105 for devo?

john wrote: sorry, maybe i do not know, okey modul CYRF6936

i only transmitter Turnigy 9x . have not Devo, i can not hacking

maybe i will buy Devo this do .

i can add all nrf24l01,cc2500,a7105 for devo?

Yes, you can add any of the 3 you mentioned BUT you can only add 2 at the same time. You would pick the 2 that you need most.

Deviation software and the transmitter only support 2 modules + the built in one for a total of 3.

Shanman3us

Shanman3us wrote:

john wrote: sorry, maybe i do not know, okey modul CYRF6936

i only transmitter Turnigy 9x . have not Devo, i can not hacking

maybe i will buy Devo this do .

i can add all nrf24l01,cc2500,a7105 for devo?

Yes, you can add any of the 3 you mentioned BUT you can only add 2 at the same time. You would pick the 2 that you need most.

Deviation software and the transmitter only support 2 modules + the built in one for a total of 3.

Shanman3us

you can add all 3 but 2 of them will require a switch that will decide which one will be connected to TCK, but if you wait a short while you will be able to have them all without issue >> www.deviationtx.com/forum/7-development/...g-a-universal-module