The forum is in read only mode.

WLtoys Q242G

23 Jan 2016 20:41 #42147 by hexfet

Replied by hexfet on topic WLtoys Q242G

Yes, I was trying to save some code space

Should be fixed now.

23 Jan 2016 20:50 #42148 by SeByDocKy

Replied by SeByDocKy on topic WLtoys Q242G

hexfet wrote: Yes, I was trying to save some code space Should be fixed now.

Ok working fine now

I will just check than rates are the same with the original TX

23 Jan 2016 20:53 #42149 by SeByDocKy

Replied by SeByDocKy on topic WLtoys Q242G

Yes ....rates are less important

... It's strange I captured stick mouvements in expert mode ...

23 Jan 2016 21:15 #42151 by hexfet

Replied by hexfet on topic WLtoys Q242G

Okay, test build is updated. May take another iteration after this as it's not clear what bits do what for rates.

23 Jan 2016 21:23 #42152 by SeByDocKy

Replied by SeByDocKy on topic WLtoys Q242G

hexfet wrote: Okay, test build is updated. May take another iteration after this as it's not clear what bits do what for rates.

Ok rates are great now but again drifting forward. I had to apply 22 rear trim to stabilize ....

23 Jan 2016 21:58 #42153 by hexfet

Replied by hexfet on topic WLtoys Q242G

Okay please try again. Should be back to same as before except for what seems to be the rate bit.

23 Jan 2016 22:04 #42154 by SeByDocKy

Replied by SeByDocKy on topic WLtoys Q242G

hexfet wrote: Okay please try again. Should be back to same as before except for what seems to be the rate bit.

seems perfect now

Great Job as usual

23 Jan 2016 22:44 #42155 by hexfet

Replied by hexfet on topic WLtoys Q242G

Thanks! I've updated the protocol_q282 pull request with the changes.

24 Jan 2016 17:28 #42173 by SeByDocKy

Replied by SeByDocKy on topic WLtoys Q242G

Demo flight

Thanks again

Time to create page: 0.496 seconds

Force desktop display