DeviationWiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Blade 130 X - Standard Settings =====

UPDATE: 5/13/13

I have updated all the models which have the same name as before.

* Notice of Ch 3 being 0 not -100 has been corrected.

* DSM2 has been changed to DSMX.
  * Throttle hold on the RUDD D/R switch.  * 7 Point Throttle and Pitch Curves.  * TX Power=100mW  * Channels=7  * Protocol=DSMX  * No Fixed ID  * Stick Mode 2
If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings.

Model 2 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S.

Model 2-2 has Zero Degree Pitch when throttle hold is on.

This will help minimize damage in a crash as the swash and blades will be at mid stick zero degrees pitch.

This will also help prevent a boom strike.

The swash does not move when TH is on.

If you want control of the swash in TH to help you land in a crash dont use this model use Model 2 instead.

Model 51 is for deviation firmware v3 and the Devo 8/8S/12.

Model 52 is for deviation firmware v3 and the Devo 10.

__Throttle Curve__ - These are the values I used then converted them to the deviation values and 7 point curves.

Normal: 0% 40% 60% 68% 75%

ST-1: 100% 90% 80% 90% 100%

ST-2: 100% Flat Across

Throttle Hold is active on RUDD D/R switch

__Pitch Curve__

Normal: -3* negative pitch. Zero degrees pitch at mid stick.

ST-1: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

ST-2: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

__DR/EXPO__

Adjust D/R and EXPO to your personal preference.

Switch Position

0- ELEV D/R = 80% EXP +30%

0- AILE D/R = 80% EXP +30%

RUDD D/R = 80% EXP LIN

Switch Position

1- ELEV D/R = 100% EXP +30%

1- AILE D/R = 100% EXP +30%

RUDD D/R = 80% EXP LIN

Download the Configuration Settings File.

Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox.

Install the configuration settings file into your models folder (See my How to video below).

This will over-right the current file so make sure that model slot doesnt

have a model being used in it. If it does rename the configuration settings file

to another number that you have free.

Example: The file you downloaded is named model5 so change the 5" to another slot

number that you dont have a model setup for. If you have model slot 6 open rename the file to model6

How to Import/Export Deviation Firmware Models

http://youtu.be/aXkvtbCXzsk

-

[[ .:blade_130_x_-_standard_settings:model52 ]] 

[[ .:blade_130_x_-_standard_settings:model52_2014-01-10 ]] 

[[ .:blade_130_x_-_standard_settings:model2-2_2014-02-01 ]] 

[[ .:blade_130_x_-_standard_settings:model2_2014-02-01 ]]
DeviationWiki

User Tools

Site Tools

Page Tools
