module 4 in 1 in devo 10

27 Jun 2018 22:04 #69726 by agustin1995

module 4 in 1 in devo 10 was created by agustin1995

hello, I have this drone

es.aliexpress.com/store/product/LIDi-RC-...3e&priceBeautifyAB=0

I have a walker 10 devo with module 4 in 1 and I can not connect to the drone. help?

28 Jun 2018 01:35 - 28 Jun 2018 01:35 #69727 by C0ckpitvue 777

Replied by C0ckpitvue 777 on topic module 4 in 1 in devo 10

It looks like the syma x5c try to bind it to that models protocol.

Last edit: 28 Jun 2018 01:35 by C0ckpitvue 777.

28 Jun 2018 01:40 #69728 by agustin1995

Replied by agustin1995 on topic module 4 in 1 in devo 10

C0ckpitvue 777 wrote: It looks like the syma x5c try to bind it to that models protocol.

it is not the same as syma x5c

28 Jun 2018 02:37 #69729 by C0ckpitvue 777

Replied by C0ckpitvue 777 on topic module 4 in 1 in devo 10

Ok,SorryI'm not familiar with it then.

28 Jun 2018 15:08 - 28 Jun 2018 15:10 #69732 by wasp09

Replied by wasp09 on topic module 4 in 1 in devo 10

I have a Llidi RC L6F.

www.rcgroups.com/forums/showthread.php?2...i-L6F-FPV-Hexacopter

It is using a protocol NOT supported by deviationtx. Not sure if it is similar to yours. You may try sending the developers a capture.

Last edit: 28 Jun 2018 15:10 by wasp09.

28 Jun 2018 18:57 #69733 by agustin1995

Replied by agustin1995 on topic module 4 in 1 in devo 10

thanks, where do I send a screen to the developers? or as a contact with them?

29 Jun 2018 13:27 #69737 by wasp09

Replied by wasp09 on topic module 4 in 1 in devo 10

Go to protocol-development of the forum. There is a SPI capture guide there:

www.deviationtx.com/forum/protocol-devel...95-spi-capture-guide

Post your capture or ask questions there.

Time to create page: 0.110 seconds