Ultimate Devo F12E (devof12e-XMS) builds

Thanks Vlad
For help and for the great work
i`ve edited last post.
A2 works fine for me

Wene001 wrote: +1 to the list of 4MB F7 Transmitters

EDIT: I tried to use the A2 pin for my a7105 CSN Line and all seems to work fine.
(No error messasges, i`ve tested FrskyX EU, Bayang and Flysky protocol)
Shutdown seems to be normal (1-2Seconds)

That's interesting! I checked the code again and played around with A2 on and off.

The A2 can be set to low and set to high again with in 10ms, but more than 20ms does turn off the TX.
And if I run 10ms on, 10ms off in loop, the leds around button starts to blink.

I guess that A2 is connected to a relay, and it is still on when average voltage is high enough.
Further checking SPI code, the CSN pin does go on and off all the time, maybe that's just enough to hold on ...
but dangerous or?

Maybe deviation developer can clarify that A2 is safe to use or not.

on the hardware side it looks that A2 is connected to nothing

Wene001 wrote: on the hardware side it looks that A2 is connected to nothing

maybe the connection is in the other layer of PCB?

the hardware connection in wiki states "output to 0 to shut off Tx" for A2 in all devo TX, e.g.
www.deviationtx.com/wiki/hardware/devof7

Good morning

I'm new.

I have installed 4MB memory on my Devo F4. All right!
I have installed two additional modules: NRF24L01; A7105; All right!

However, I can only use protocols that do not have auto-binding.

Protocols that have self-binding can not use them, because they are labeled as "re-initialize!"

How can I bind these protocols?

Thanks for the help

I understand how to make auto-binding with the following video.



However, an observation is needed:

The field has two values << Bind >> and << Re-init >>.
The <<Re-init >> value is typical of a module not installed!

This is fortifying!

The field should have three values:
<< Bind >> With Fixed ID
<< Re-init >> When the module is not installed and then the protocol can not be used.
<< Auto >> When the protocol can be used but we have to do the self-Binding.

Greetings

Do you have uncommented the Modules in Hardware.ini?
Use Notepad++ to edit the file.

Protocols that have a * in the menue are not configured properly and cannot be used

xuyuan wrote: maybe the connection is in the other layer of PCB?

Of course there could be a via under the Chip.
At least for me its working this way without noticeable problems

Protocols for uninstalled modules are referred to as << Re-init >> exactly as protocols for installed modules that require auto-bind.

By scrolling through the menu, how do I know if it is a protocol I can use in auto-binding or a protocol that I can not use because the module is not installed?

Thanks

Can I is my devo.fs file from my f12e on F7 or do I need to use the F7 and add my models in it and reapply? I can't get DSM2 or DSMX to work. I get a message saying missing mod when I try using those protocols.

Vlad, I figured that out before I read your post. My Devo F7 is up and running! Thanks for the help I pulled the OG Devo.fs file from the nightly build and just moved my models into the folder and ran the build, copy and pasted and vola no more protocol error and my birds are bound and flying high!