I have a devo 7e and i just installed a 4 in 1 module. I connected the 2401 to the 50th pin on the one controller pin, and connected the 2500 to pin 10 on the control board and the 7105 to the pin 9 on the control board. What should I modify the hardware.ini to from this...
[modules]
; there is no need to enable the cyrf6936 module unless
; it is wired to an alternate port. It is Enabled automatically otherwise
; enable-cyrf6936 = B12
has_pa-cyrf6936 = 0
; enable-a7105 = A13
; has_pa-a7105 = 1
; enable-cc2500 = A14
; has_pa-cc2500 = 1
; enable-nrf24l01 = A14
; has_pa-nrf24l01 = 1
; enable-multimod = A13
