Joomla says you aren't logged in
release_notes:3.0.0
Table of Contents
Version 3.0.0
Version 3.0.0 was released on
This is a major release of the Deviation firmware
IMPORTANT: You must install the filesystem along with the new firmware. Make sure to save your models first!
Major Features
- Devo7e support
- Devo12 support
- Note that the Devo12 support uses the Devo8 GUI and does not take full advantage of the larger screen yet
- New 'standard' GUI for helicopters
Minor features
- Telemetry support for DSM2/DSMX
- New protocols
- DSMX
- Skyartec (needs CC2500 module)
- WLToys protocol extensions
- Repetitive low-battery alarm
- Multiple hardware modules are supported
- Support for hardware modules with or without power amplifier
- PPM has more configuration options
- Support for multiple icons per switch
- Also support switch icons for Devo10
- New 'permanent' timers
- Add error-catching code to make it possible to debug reboots/hangs
Incompatibility
- Switches are now numbered (e.g.GEAR0, GEAR1). Deviation will properly convert old models, but older versions of Deviation will not properly support models made for version 3.0 or newer
- The channel scale is applied after the safety value. If safety is in use, make sure to check the values
- The toggle icon locations have changed. Generally all models will need to be reconfigured to use the new icons. This was unintentional, but not easily rectified at this point.
- If upgrading from a previous Deviation release and using an A7105 module (Flysky/Hubsan), the module will be initially disabled until you follow the directions here: https://www.deviationtx.com/forum/6-general-discussions/1572-flysky-module-users-you-need-to-read-this
release_notes/3.0.0.txt (53036 views) · Last modified: 2017/01/23 00:44 by FDR