Eachine E010 inductrix clone data captures

As long as I set the power to 1mW I can bind my Devo 10 without issues. I've been flying for a while but realised that with bog standard settings I am flying on low rates. Any suggestions how to increase those and assign to a switch? Someone posted a file, probably on RC Groups but can't find it again, that had all functions programmed. However I get a weird behaviour when I use that file. It will bind and I can fly around but then all of a sudden the motors will start to rev seemingly at random. With the basic model file that does not happen.

Anyone care to help a noob out, trying to get my e010 bound to my 8s and it does bind however the screen is almost completely black therfore I can't see my inputs and such.

Hello goebish, i have my E010 since yesterday, and it's ok for blind to my Devo 7e, the fly it's very good in 30mw but to 100 or 150 mw the tiny have a bad réaction, i say that juste for info because for me it's very nice and 30mw .Again great take you for your job.

I also captured mine:

gist.github.com/schwabe/9e8563f1abecbee4660763e798e4ee78

Maybe mine has a useful TX ID for decoding.

I was lazy and put it in the same gist: gist.github.com/schwabe/9e8563f1abecbee4...#file-h010-logicdata

ShouId I use nightly build to bind E010 I'm using deviation 5.0.0 ???

i had already installed the NRF24L01 module into my devo 8. i also enable it at harware.ini file. i download the the lastest nightly build n e010 file. still i cant find at my transmitter e010 format under mqjx protocol. what seem the problem here?? help

Hi everyone,

I don't know what I am doing wrong but I just can't get my E010 to bind with my Devo7e.
I have installed an NRF24L01 module and it works with an Eachine H8S.

I do have the latest nightly build installed and I chose the E010 in the model menu.

I have also tried serveral other Transmitter IDs and some older nightly build versions.

I really hope you can help me because the provided "Transmitter" ´just sucks

Greetings

Captured a bind with my TX.
First time I used a logic analyzer... tell me if something's wrong.
I captured with sigrok/pulseview, was unable to connect saleae Logic to my analyzer.


raw file : mega.nz/#!bpdWjABQ!kummASmxbweEplsSBtdlpSVaaRUbw_oTBAS5dvS-Euk
sigrok file : mega.nz/#!jtlSkQJY!iR0mLEv84bNrexxksFGffiQft--WJ6e1H4hdNMAMyTg

Hope it helps.

E010
txid: ee b3
channels: 39 3e 49 4e

Hey, goebish, is it easy to solder to the quad itself?

Sad. One of the tricks I applied is to program arbitrary id and watch what channel the receiver starts listen to. You can recover the hopping sequence relatively easy.

I'm having a similar issue on my 10e. The quad will bind at 1mW, but will cut out control every few seconds, so it can get kind of dangerous to fly. Not quite sure what can be done to increase the current to the module.